CJMCU 64 Bit 8×8 RGB LED Driver Development Board

CJMCU 64 Bit 8×8 RGB LED Driver Development Board

1,290.00

QUICK OVERVIEW

  1. Dimensions : 66 x 66 x 3 mm.
  2. Weight : 25 gm.
  3. Supply Voltage : 5 VDC.
  4. Interface : IO .
  5. 8 x 8 = 64 RGB.
  6. Chip : WS2812b.
  • Description

Description

CJMCU 64 Bit 8×8 RGB LED Driver Development Board a large board with 64 WS2812 RGB LEDs arranged in an 8×8 matrix. Each LED is capable of drawing as much as 60mA (at peak brightness the matrix can draw just over 3.5 Amps at 5 Volts), this adds up so it is suggest to use a 5V 2A power supply. For most uses, you’ll see about 1-2A of current per panel.

There are two 3-pin connection ports to wire board. Solder wires to the input port and provide 5VDC to the +5V and ground pins, then connect the DIN pin to your micro-controller and make a common ground from the 5V power supply to the micro-controller/Arduino.

Additionally, you can chain as many panels together as you’d like. For the second panel, connect the DIN connection to the first panel’s DOUT, connect the ground pins together and power with 5V. It should be note that after four or more panels you may run low on RAM if you’re using an Arduino Uno and you may need a 5V 10A power supply for so many of these!

Every stick is equip with a single data line with a very timing-specific protocol requiring a real-time micro-controller with a 8MHz or faster processor such as an AVR, Arduino, PIC, mbed, etc. There are solder pads on the back for connecting wires or breadboard pins and two mounting holes for securing this board to many different surfaces.

Package Includes :

1 x CJMCU 64 Bit 8×8 RGB LED Driver Development Board.

Specifications and Features :

  1. Dimensions : 66 x 66 x 3 (LxWxH)mm.
  2. Weight : 25 gm.
  3. Supply Voltage : 5 VDC.
  4. Interface : IO
  5. 8 x 8 = 64 RGB
  6. Chip : WS2812b